TB6612FNG / TB6612 Dual Motor Driver 1A Waterproof sensor Melting point: 227 ° C

Melting point: 227 ° C

Reinforcing plastic with carbon fibers produces a 3D printing filament which exhibits the best properties of both the carbon fibers and the plastic of choice

are not included in the package

Normally Open [NO]) are accessible through screw terminals which makes wiring up the board very easy

TB6612FNG / TB6612 Dual Motor Driver 1A Waterproof sensor Melting point: 227 ° CThe TB6612FNG Motor Driver can control up to two DC motors at a constant current of 1. 2A (3. 2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes: CW, CCW, short brake and stop. The two motor outputs (A and B) can be separately controlled, and the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz. The STBY pin should be pulled high to take the motor out of